Table of Contents
Advertisement
6-4-5. Prmib Command
This command is used to show the settings of the MIB parameters.
Command format : prmib
Execution example
1. Enter "prmib".
Settings of the MIB parameters are displayed.
SNMPCmd> prmib
01: sysContact = ""
02: sysName = ""
03: sysLocation = ""
04: snmpEnableAuthenTraps = 1
01: Information indicating system administrator, and others.
02: Names such as the name for system administrator, and others.
03: Information such as physical location of the system, and others.
04: The flag that is used for judgment when creating the Authentication Failure Trap by the SNMP
Agent.
1 = Enable
2 = Disable (Factory setting)
6-4-6. Loadmib Command
This command is used to returns the MIB settings to the original settings that have been backed up
beforehand.
Command format : loadmib nnnnn
The serial number is verified with the serial number (nnnnn) entered by user. After that, the MIB settings
are returned to the original settings that have been backed up beforehand.
If the serial numbers do not match, an error is issued and the MIB settings cannot be read.
Execution example
1. Enter "loadmib 10001".
The MIB settings are read.
SNMPCmd>loadmib 10001
Success to load settings.
6-8 (E)
PDJ-A640 IM
Advertisement
Table of Contents
