Installation And Settings When Connecting The Pdj-Cs10 (Cart If) To The Cart; Setting The System Frequency (Ntsc Df/Ndf And Pal); Setting The Interface (Rs-422A And Rs-232C); Removing The Board Cover Of The System Control Board (Node Board) - Sony PDJ-A640 Installation Manual

Installation and Settings when Connecting
This chapter describes the procedures for installation and setup when connecting the control system
middleware PDJ-CS10 (CART IF).

5-1. Setting the System Frequency (NTSC DF/NDF and PAL)

Setting the Interface (RS-422A and RS-232C)

5-1-1. Removing the Board Cover of the System Control Board (Node Board)

c
Be sure to turn off the main power of the system before removing any parts.
(1) Turn off the power switches of Robot and Main at the lower right of the front panel.
(2) Unplug the power cable from the AC inlet on the rear side of the main unit.
1. Remove the four screws and remove the lower rear
cover.
2. Remove the two fixing screws of the system control
unit in the lower most-stage, and draw out the system
control unit.
System control unit
PDJ-A640 IM
Section 5
the PDJ-CS10 (CART IF) to the CART
Lower rear cover
B4 x 6
B3 x 6
3. Remove the two screws, and remove the board cover.
B3 x 6
Board cover
System control board
System control unit
5-1 (E)