Table of Contents
Advertisement
5-10. Setup and Setting List
Settings for the system frequency and the interface: Settings for the system control (NODE) board
Dip switch S4
Dip switch S8
Barcode type settings
Check by a test mode 40.
Test mode 40
Main CPU/Robot IF board settings
Dip switch S2
Cable connection to CART, CART IF, upper-level APL, external DECK, etc.
Conversion connector when connecting the RS-422A of CART and a PC or other devices
Settings for built-in DECK
Software version
When PDW-F70 is built-in
When PDW-F75 is built-in
When PDW-HD1500 is
built-in
Menu settings
Check connection to ftp
CART version
→ Check by a test mode 35.
Supported for PDW-F1600 to be mounted
1.
2.
Optimization of the bin position
→ Check by a test mode D0.
GUI check after PDJ-CS10 is installed
5-18 (E)
System frequency
NTSC Drop Frame
NTSC Non-Drop Frame
PAL
Interface
RS-422A termination ON
RS-422A termination OFF
RS-232C
Single-line mode
(Three-line mode)
Barcode mode
Single-line mode
(Three-line mode)
Set the switch for the conversion connector (K2 connector)
Switch settings: Bits 1,4 to 6: OFF/Bits 2 and 3: ON
PDW-1500: Ver 1.56 / PDW-HD1500: Ver 1.51 or higher
PDW-F70/F75: Ver 1.98 or higher / PDBK-101: Ver1.81 or higher
PDW-F1600: Ver 1.51 or higher
Attach PDBK-A640
Attach PDBK-A640/PDBK-104
When recording data with SD/HD mixed: Attach PDBK-S1500 or
PDBK-F1500.
1. 525/625: After setting, turn the power off and on again.
2. IP address: After setting, turn the power off and on again.
3. Enable the extended menu display.
4. n&9pin
5. free mode
6. Specification of national date and time
7. Use the function key F1 to set V INPUT to SDSDI or COMPOSIT for
PDW-F75.
8. In the case of PDW-HD1500/F1600:
When recording USER DATA: Set PROAV DISPLAY to ena.
When recording data with SD/HD mixed to a single DISC: Set MIXED
REC to ena.
9. Set the toggle switch to Remote .
From PDJ-CS10, enter the IP address for the DECK into the
ftp and check the response.
Node Main
Sub
Robot
Upgrade the versions to Node Main: V2.29 or higher, Sub: V1.13 or higher.
Upgrade the versions to Robot: V2.19 or higher.
Robot side: Set A097 to DEVICE 4.
Set the Y direction data (-0035) for elevator.
Node side: Enter the Menu Sense command.
Enter the data into CUSTOM 7.
1. Config Manager
2. Cart Status
S4-1
S4-2
OFF
OFF
OFF
ON
ON
OFF
S8-1
S8-2
ON
ON
ON
OFF
OFF
OFF
BARCODE CHECK 1L
BARCODE CHECK 3L
S2-5
S2-6
OFF
ON
OFF
OFF
V2.29 or higher
V1.13 or higher
V2.19 or higher
Check
DECK1
DECK2
DECK3
DECK4
PDJ-A640 IM
Advertisement
Table of Contents
