Toshiba V Series User Manual page 94

Chapter 10 Maintenance Using V-Tool
Code
0x0103
0x1101
0x1102
0x1104
0x3101
10
0x3102
0x6102
74
Contents
Text parameter error In the specification of the transmission area,
*Head address in Area1: beyond the limits of 0 to 511. (In the case of
* Head address in Area1: beyond the limits of 0 to 504. (In the case of
*Area length in Area1: beyond the limits of 0 to 512. (In the case of master
* Area length in Area1: beyond the limits of 0 to 505. (In the case of
* The area specified by head address and the data length in Area1:
* The area specified by head address and the data length in Area1:
* Head address in Area2: beyond the limits of 512 to 8703.
* Area length in Area2: beyond the limits of 0 to 8192.
* The area specified by head address and the data length in Area2:
In a time set command, data of calendar/time is abnormal.
STX/ETX error A transmission frame received from V-Tool has abnormal text.
Text size error A transmission frame received from V-Tool is oversized
CRC error異常 A transmission frame received from V-Tool has abnormal CRC code
Control mode FL654 is set to TOOL specification; the operation mode command from
command error V-Tool doesn't suit the operation mode of FL654.
RUN/HALT sw
RUN
RUN
HALT
HALT
RUN
RUN
-
-
When I/O configuration is abnormality, FL654 is received Run command
from V-Tool.
Memory clear FL654 is set to TOOL specification; FL654 is received "memory clear" when
command error FL654 is I/O run mode or Down mode.
EEPROM access Writing in EEPROM is failure or read-out from EEPROM is failure.
error
master station calendar/Time setting function not used.).
master station calendar/Time setting function used.).
station calendar/Time setting function not used.).
master station calendar/Time setting function used.)
beyond the limits of 0 to 511. (In the case of master station
calendar/Time setting function not used.).
beyond the limits of 0 to 504. (In the case of master station
calendar/Time setting function used.).
beyond the limits of 512 to 8703.
FL654 operation mode
I/O run mode
Down mode
-
-
Halt mode
Down mode
I/O run mode
Halt mode
Model 2000 FL-net (OPCN-2) Remote I/O Station Module (FL654) User's Manual
Factors
V-Tool command
Run command
Run command
Run command
Halt command
Halt command
Halt command
Error reset command
Error reset command