Chapter 4 Configuration, Installation, And Wiring; Configuration Of The Fl654 Remote I/O Station - Toshiba V Series User Manual

Chapter 4 Configuration,
Installation, and Wiring
Provides descriptions of the configuration, installation, and wiring of the FL654.

4.1 Configuration of the FL654 Remote I/O Station

The FL654 remote I/O station has the same system configuration as the basic hardware
configuration 2 (standalone module) of the integrated controller model 2000 sequence
controller S2. For more information on this, see the following document:
• Integrated Controller Model 2000 Sequence Controller S2 Basic Hardware User's
Manual (6F8C0836)
The basic unit consists of the power module, FL654 (standalone module for S2), and I/O
modules. Expansion of the basic unit requires installation of an expansion interface. The
expansion unit consists of the power module, I/O modules, and expansion interface. The
basic and expansion units are connected using an expansion cable.
Figure 4-1 shows the configuration diagram.
Both the basic and expansion unit bases must be installed to a vertical panel with the
power modules located at the left.
Power module
Expansion
interface
Power module
Expansion
interface
6F8C1120
FL654
Empty slot (only in the case of BU668)
Figure 4-1 Configuration of the Remote I/O Station
4.4 通信ケーブルの接続
Basic unit
Dual-purpose
basic and
expansion base
I/O modules
Expansion unit
Dual-purpose
basic and
expansion base
I/O modules
11