Trailing Arm Spherical Bearing Replacement - Polaris RZR XP 1000 2014 Service Manual

STEERING / SUSPENSION
TRAILING ARM SPHERICAL BEARING
REPLACEMENT
1. Remove trailing arm (see Chapter 8 – Trailing Arm
Removal / Installation, page 8.17).
2. Remove bushings and O-rings.
3. Remove snap ring
bearing.
4. Properly support the trailing arm and press the
spherical bearing out of trailing arm casting.
8.20
q
that retains the spherical
5. Be sure to only press on outer most surface of
bearing race, do not press on the center spherical
bearing.
6. Inspect trailing arm bearing housing for wear or
damage. Replace trailing arm if damaged.
7. Press in new bearing until fully seated into trailing
arm casting.
8. Install new snap ring, O-rings (not required) and
bushings.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.