Polaris RZR XP 1000 2014 Service Manual page 277

w
7. Remove the four bolts (
lower radius rods to the bearing carriers (left and right
side). Discard nuts and replace with new upon
assembly. Allow the radius rods swing downward.
8. Lift training arms up and swing trailing arms outward
to remove the drive shafts from the transmission.
9. Maneuver the drive shafts out of the vehicle frame.
Reinstall the lower shock bolts
arms up during the rest of the removal procedure.
10. Remove vent hose from transmission.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
attaching the upper and 11. Remove the gear position switch connector
12. Remove
e
to hold the trailing
13. Place a spacer or support between the vehicle frame
t
sensor connector , crankshaft position sensor
r
connector , shift bracket bolts and shift bracket
shift cable clevis pin and washer
transmission.
the wire ties
transmission and mounts.
and engine to hold the engine up in position or
support the engine from the top side using an
overhead lift.
TRANSMISSION
y
, speed
u
,
i
from the
retaining harness to
6
6.7