Water Pump Housing Removal - Polaris RZR XP 1000 2014 Service Manual

Table of Contents

ENGINE / COOLING SYSTEM

5. If bearing replacement is required, remove the

retaining ring and heat the stator cover around the

bearing evenly with a heat gun. Tap cover on a soft

work surface to remove the bearing from the

housing. A blind bearing puller can also be used.

Replace bearing if removed.

WATER PUMP HOUSING REMOVAL

The water pump housing can be serviced with the

engine installed in the chassis (see Chapter 3 – Water

Pump Removal, page 3.21).

1. Remove the coolant lines from the thermostat

housing, cylinder inlet and oil cooler. Leave them all

attached to the water pump housing.

2. Remove the three long gold colored bolts

retaining the water pump housing to the engine.

3. Remove the water pump assembly from the engine

by using a twisting motion as you pull out on the

4. If water pump service is required (impeller or

mechanical seal), refer to Water Pump Service, page

9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual

Table of Contents