Required Cables - HP 5501A Operating And Service Manual

J
.
- -
REFEREPICE SIGNAL
-
REPLICATED
AND ROUTED TO OUTPUT DEVICE
#2
*15 VOLT ROUTED TO
215 VOLT POWER CABLE
*lSV
10780A
02
+15V ROUTED TO
N -
10780A trl (INTERNAL)
REFERENCE SIGNAL-
RF CABLE I I
++--
, '
/
/
10780A
RF CABLE JUMPERS.
OUTPUT DEVICE
U l
RECEIVER
*15V. AND REPLICATED
10760A COUNTER.
REFERENCE 'IGNAL To
OUTPUT DEVICE ft2
MEASUREMENT SIGNAL
*2
-
-+15V
lO780A
+15V ROUTED
/
OUTPUT DEVICE # 2
RECEIVER 107M)A COUNTER,
10780A #2
107648 FAST PULSE CONVERTER. ETC
5.3 REQUIRED CABLES A N D PRELIMINARY PROCEDURES
NOTE
During system installation and checkout, power must be frequently applied
to and removed from the system. Therefore, it is recommended that all of
the unit line cords (e.g., power supplies, calculators, etc.) be connected to
a common source with a main
ON/OFF
switch. This will make
it
more con-
venient to apply and remove system power.
The mains plug shall only be inserted in a socket outlet provided with a
protective earth contact. Before plugging in, make sure the source voltage
matches the input rating of the power supplies.
Prior to mounting any equipment, perform the following steps:
a. Unpack and inspect all of the equipment (each of the unit manuals contain unpacking
and inspection procedures).
b.
Check to determine if you have all of the cables necessary for your system (see Tables-2).
If required, fabricate the necessary system cables (refer to Appendix E, BACKDATING
for fabrication instructions).
c. Set up the 5501A Laser Transducer Head, the 10780A Receiver, and the Power Supplies
in a clear area.
NOTE
Prior to using the power supplies read the applicable manuals and set
them up a s follows:
I. The +15V Power Supply i s set for local sensing, and current limiting.
(See Figure 5-4).
2. The +5V Power Supply is set for single output, remote sensing, anci
current limiting. (See Figure 5-4).