Slip Ring Brush Assembly Replacement - Sony Betacam SX DNV-5 Maintenance Manual

3-2-2. Slip Ring Brush Assembly Replacement

Outline
Replacement
Brush cover removal
Brush assembly removal
Brush assembly installation
Brush cover installation
Precaution
Replace the brush assembly when the brush is worn.
Install the brush assembly in the procedure below. The relative height and contact
pressure with the slip ring are then adjusted automatically. In this case, the
adjustment after replacement is not required.
Never clean the brush surface using cleaning cloth moistened with cleaning fluid.
Preparations
1. Turn off the power.
2. Remove the front lid and outside panel.
(Refer to section 1-6 in Part 1 of the Maintenance Manual.)
n
The brush assembly can be replaced with the cassette compartment installed in the
unit.
Tools
. Torque screwdriver bit (for M2)
. Torque screwdriver (for 3 kg)
DNV-5
DNW-7/90/90WS
J-6325-380-A
J-6325-400-A
3-2-2. Slip Ring Brush Assembly Replacement
3-17