Sony Betacam SX DNV-5 Maintenance Manual page 149

(4) Hold the position of the cassette compartment
shown in the figure and install it in the
chassis so that the two cassette guide pins are
put in the round holes of the stage. At that
time, confirm that the other white roller of the
eject arm of which position was adjusted in
step (1) is put in the notch of the cam plate
(A) on the right side panel.
(5) Push the lever of the cassette compartment
and confirm that the stage smoothly moves
up and down. If not, reconfirm steps (1) and
later.
(6) Install the cassette compartment with three
screws.
[Tightening torque:
9 x 10 _2
N.m (0.9 kgf.cm)]
DNV-5
DNW-7/90/90WS
Screws
( M 1.4 x 3.5 )
Lever
Round hole
of the stage
Cassette guide pin
Notch
White roller
(step1)
Joint arm
3-3-24. Cassette Compartment Replacement
Screws
( M 1.4 x 3.5 )
Stage
Notch of the
cam plate (A)
Cassette
Other
guide pin
white roller
3-99