Description Of Nonvolatility Memory's Data; Electrical Adjustment After Replacement Of Block Or Board - Sony Betacam SX DNV-5 Maintenance Manual

6-5. Description of Nonvolatility Memory's Data

6-6. Electrical Adjustment After Replacement of Block or Board

6-5. Description of Nonvolatility
Memory's Data
Explains the holding data of nonvolatility memories on the
boards.
When replace the following boards, remove the nonvolatil-
ity memory on the old board and attach it on the new
board.
n
When the nonvolatility memory is replaced with a blank
memory, the setup operation is needed.
If the memory is replaced, please consult your Sony
service representative.
Board name Ref. number
TC-80 IC711
AIF-8 IC102
6-4
Data
Hours meter data
VTR mode setting data
Equalizer adjustment data
Video recording current
adjustment data
IF-634 board adjustment data
(DNV-5 only)
Machine-specific setting data
6-6. Electrical Adjustment After
Replacement of Block or Board
Block name/board name Adjustments
CCD block 8-3. AD Clock Phase Adjustment
DCP-1 board 8. Camera System Adjustment
(When you require the fine-
adjustment.)
DVP-1 board 7-8. Equalizer Adjustment
7-9. Recording Current Adjustment
TC-80 board 7-2-1. Battery End Detection
Adjust the voltage after removing
IC711 on the old board and
attaching it on the new board.
AIF-8 board Remove IC102 on the old board
and attach it on the new board.
Other board No adjustment is required after
board replacement
Drum 7-8. Equalizer Adjustment
7-9. Recording Current Adjustment
Capstan motor 7-3. Servo System Adjustment
Timing belt 7-3. Servo System Adjustment
Voltage Adjustment
DNV-5
DNW-7/90/90WS