Full-Top Sensor Assembly Replacement - Sony Betacam SX DNV-5 Maintenance Manual

3-3-22. Full-Top Sensor Assembly Replacement

Outline
Replacement
Full-top sensor assembly removal
Full-top sensor assembly installation
Preparations
1. Confirm that the unit is in the unthreading end state.
2. Turn off the power.
3. Remove the front lid and outside panel.
(Refer to section 1-6 in Part 1 of the Maintenance Manual.)
n
The full-top sensor assembly can be replaced with the cassette compartment in-
stalled in the unit.
Tools
. Torque screwdriver bit (for M1.4)
. Torque screwdriver (for 32 kg)
Removal
1. Full-top sensor assembly removal
(1) Remove one screw securing the full-top
sensor assembly.
(2) Remove the full-top sensor assembly while
disconnecting connector CN512 on the
MDC-5 board.
Installation
2. Full-top sensor assembly installation
(1) Connect the connector of the full-top sensor
to connector CN512 on the MDC-5 board
while aligning the positioning pin at the
bottom of the full-top sensor assembly with
the longitudinal hole of the cassette stopper.
(2) Push the full-top sensor holder in the direc-
tion indicated by arrow A so that its tip
strikes against the surface of the lower drum
and tighten the screw for the full-top sensor
assembly.
[Tightening torque:
_2
9 x 10 N.m (0.9 kgf.cm)]
DNV-5
DNW-7/90/90WS
http://getMANUAL.com
J-6325-110-A
J-6325-400-A
Screw (M1.4 x 3.5)
Full-top sensor assembly
3-3-22. Full-Top Sensor Assembly Replacement
Connector
A
Positioning pin
CN512
MDC-5 board
3-95