Sony Betacam SX DNV-5 Maintenance Manual page 124

3-3-13. Gear Block Assembly Replacemen
9. TC head assembly installation
(Refer to section 3-3-7.)
10. VH cleaner assembly installation
Install the VH cleaner assembly and hook the
spring. (Refer to section 3-2-5.)
11. Manual eject drive installation
(1) Pass the compression spring and manual eject
gear removed in procedure 1 through the
shaft of the chassis.
n
Install the manual eject gear with the hook of
the clutch upward.
(2) Install the manual eject drive onto the shaft of
the chassis and push fully until hooked by the
gear block assembly.
(3) Confirm that the gear at the top of the capstan
motor engages with the gear of the manual
eject drive when the manual eject drive is
pushed downward. Moreover, confirm that
the manual eject drive smoothly returns to the
former state when it is released.
3-74
VH cleaner assembly
Manual eject
drive
Manual eject
gear
Compression spring
Spring
Hook
DNV-5
DNW-7/90/90WS