Shielding D-Sub Connectors; Fig. 7-27: Shielding D-Sub Connectors - Bosch Rexroth IndraControl VCP 08.2 Project Planning Manual

R911310379 / 02 | Rexroth IndraControl VCP 08
Interfaces
7.4

Shielding D-SUB Connectors

Electric Drives and Controls | Bosch Rexroth AG
You must shield D-SUB connectors as follows:

Fig. 7-27: Shielding D-SUB connectors

1 D-SUB connector
2 Shield
3 Cable clip
4 Cable
The shield must be folded back into a flat position over the cable
sheath.
When fastening the cable with the cable clip, as much of the shielding
as possible must be in contact with the housing and sufficient strain
relieve must be ensured.
7-15