Bosch Pack201HS Instruction Manual page 85

Pack201 | Operator Interface | Section 4
Message
SHORT PRODUCT REJECT�
HIGH PRODUCT REJECT�
LOW PRESSURE FEEDER INCREASING�
LOW PRESSURE FEEDER DECREASING�
SIDE CHAIN INCREASING�
SIDE CHAIN DECREASING�
LINESHAFT X INCREASING�
REJECT VERIFICATION ERROR�
GENERIC REJECT
SYNC REJECT�
VISION REJECT
VISION DATA NOT VALID STOP�
VISION SYSTEM CONSECUTIVE STOP�
SHORT PRODUCT CONSECUTIVE STOP�
VISION SYSTEM NOT READY�
FINWHEEL/PFR SWITCH OPEN�
MISSED REGISTRATION MARK CONSECUTIVE
STOP�
POWER FEED ROLL IS TOO TIGHT�
NO PRODUCT / NO PAPER EYE ERROR�
MFG SPLICE EYE ERROR�
VERIFICATION EYE ERROR�
BAD CONFIGURATION FILE�
OPTIONAL GUARD OPEN�
EPROM WRITE FAILURE�
OVERHEAD SWEEP FOLLOWING ERROR�
© Bosch Packaging Technology, Inc.
All rights reserved 2012
SHORT PRODUCT DETECTED AND REJECTED�
HIGH PRODUCT DETECTED AND REJECTED�
CHECK THE FEEDBACK PUSH THE ESTOP BUTTON TO RESET THE
FOLLOWING ERROR OR PRESS START BUTTON TO RUN�
THE LPF IS DECREASING TO THE NEW OFFSET�
THE SIDE CHAIN IS INCREASING TO THE NEW OFFSET�
THE SIDE CHAIN IS DECREASING TO THE NEW OFFSET�
THE LINESHAFT IS INCREASING TO THE NEW OFFSET�
A PRODUCT THAT WAS TO BE REJECTED WAS DETECTED BY THE
VERIFY EYE� REMOVE THE PRODUCT� PRESS START BUTTON TO
RUN�
GENERIC REJECT DETECTED AND THE PRESET AMOUNT OF
PRODUCT HAS BEEN REJECTED�
MACHINE LOST SYNCHRONIZATION AND THE PRESET AMOUNT OF
PRODUCT HAS BEEN REJECTED�
VISION REJECT DETECTED AND THE PRESET AMOUNT OF PROD-
UCTS TO REJECT HAVE BEEN REJECTED�
MACHINE CYCLE STOPPED BY DATA VALID SIGNAL NOT TRANSI-
TIONING� CHECK THE WIRING AND VISION SYSTEM FOR ERRORS�
THE MACHINE HAS CYCLE STOPPED BECAUSE MORE REJECTS
HAVE CONSECUTIVELY OCCURED THAN THE PRESET AMOUNT AL -
LOWS�
CHECK THE PRODUCT FOR SHORT/MISSING� CHECK THE PROD-
UCT FLOW FOR ERRORS�
MACHINE CYCLE STOPPED BY VISION SYSTEM THE VISION SYS-
TEM FOR ERRORS�
CLOSE THE SWITCH(ES) AND PRESS START TO RUN�
CHECK THE FILM TRACKING AND THE REGISTRATION EYE�
CHECK FOR THE POWER FEED ROLLERS TO BE OPEN
CHECK THE PRODUCT FLOW AND THE EYE SETUP�
CHECK THE TWO EYES IN THE CIRCUIT AND MAKE SURE
BOTH ARE SEEING AT THE SAME TIME�
CHECK TO SEE THAT GOOD PRODUCT IS PASSING IN FRONT OF
VERIFICATION EYE� THEN CHECK SETUP OF EYE�
THE MACHINE CONFIGURATION FILE HAS BECOME CORRUPTED
CLOSE THE GUARD TO RUN THE MACHINE�
NOTIFY THE FACTORY�
CHECK THE FEEDBACK PUSH THE ESTOP BUTTON TO RESET
FOLLOWING ERROR OR PRESS START BUTTON TO RUN�
Action
EN | 54