Bosch Pack201HS Instruction Manual page 20

Pack201 | Operator Instructions | Section 3
3.2 During Production
During production, periodically examing the following
items�
Examine both the endseals of the packages. If the seal
is not correct:
• Check the crimper temperature setting�
• Check for dirty crimpers
• Check the crimper clearance�
• Check the crimper pressure�
Examine the longitudinal seal on the package. If the
seal is not correct:
• Check the finwheel temperature setting.
• Check for dirty finwheels.
• If package is too loose, adjust the cant on the first
finwheel assembly.
• If the film edges are not even, turn the centering
knob to adjust�
Examine the film flow into and out of the former/fold-
ing box. If film is not flowing properly:
• Check to make sure the material is centered and
remains mated properly in the former�
• Check the position of the inclination arm and
roller on the backstand�
• Check position and alignment of the former wings�
Prepare Second Film Roll
1� Mount the second film roll on the backstand, if
equipped�
2� Unroll some film until two registration marks can
be seen�
3� Cut the film halfway between the two marks.
4� Apply double-sided tape 25 mm from the cut end
of the film.
5� Trim off the corners of the film.
6� Attach the new film to the end of the old film so
that the registration marks align�
© Bosch Packaging Technology, Inc.
All rights reserved 2012
EN | 4