Bosch Pack201HS Instruction Manual page 76

Pack201 | Operator Interface | Section 4
PARAMETER
Angle On Pulse X (deg)
Angle On Reject Verify (deg)
Angle On Short Product Reject (deg)
Angle On Tucker (deg)
Angle On Uncut Reject (deg)
Angle On Window Stop
Auto Delay Off (mm)
Auto Delay On (mm)
Backlog Belt Accel Begin
Backlog Belt Decel Begin
Backlog Belt Hi Rate Accum Hi Speed
Ratio (%)
Backlog Belt Lo Rate
Backlog Gap Close Eye Enable
Backlog Gap High Delay (mm)
Backlog Gap High Ratio (%)
Backlog Gap Low Delay (mm)
Backlog Gap Low Ratio (%)
Backlog To Infeed Ratio (%)
Coder Enable
Coder Offset
Consecutive Rejects Allowed
Cut Head to (Pusher) Dropout (mm)
Cut Position (mm)
(See Registration Offset)
© Bosch Packaging Technology, Inc.
All rights reserved 2012
DEFINITION
This is the position in a cycle where pulse X begins�
This is the position in a cycle where the verification eye starts to check
for a product�
This is the position in a cycle where the short product reject eye starts
checking for a short product�
This is the position in a cycle where the air tucker starts to activate for a
tuck in the package�
This is the position in a cycle where the uncut eye starts to check for an
uncut package�
This is the position in a cycle where the stop window begins�
This is a delay added to prevent the wrapper from stopping as soon as
the No Product eye is unblocked�
This is a delay added to prevent the wrapper from starting as soon as
the No Product eye is blocked�
This is the point during a machine cycle at which the backlog belt starts
to accelerate to high speed�
This is the point during a machine cycle at which the backlog belt starts
to decelerate to low speed�
This is a percent of the backlog belt base rate used to set the high
speed required while product is fed into the sweep area�
This is a percent of the backlog belt base rate used to set the low speed
required during the product transfer�
In the ON position the backlog gap closing eye is active� In the OFF posi-
tion the eye is disabled�
This is the distance the backlog eye is unblocked before the backlog belt
speeds up�
This is a ratio of the backlog belt speed to 100 to 200% of the base
speed when the speed eye is blocked�
This is the distance the backlog eye is blocked before the backlog belt
slows down�
This is a ratio of the backlog belt speed to 50 to 100% of the base speed
when the speed eye is unblocked�
This is the ratio between the backlog belt speed and the infeed chain
speed�
In the ON position the coder is active� In the OFF position the coder is
disabled�
This is a correction that may be added to change the position of the
code on the package�
This is the maximum number of consecutive reject conditions detected
allowed before the wrapper stops�
This is the measured distance from the closed crimpers to the point
where the infeed pusher last contacts the product�
This is the position of the cutoff on a package when running registered
film.
EN | 45