Bosch Pack201HS Instruction Manual page 118

Pack201 | Maintenance | Section 6
8. Repeat this process until a good cut is
achieved. Fully tighten the set screws.
NOTE: The knife should be adjusted out
just far enough to make a cut and not
affect the seal. If the knife extends too
far, it will cause a poor end seal and
premature knife wear.
Install the Knife (shim style)
Combinations of shims are used to set
the height of a shim-style knife. Shims are
available in .002", .003", .005", and .010"
thickness. Use the fewest number of shims
to achieve the proper height (for example:
use one .010" shim instead of five .002"
shims).
1. Install the knife in the knife crimper
without any shims and tighten the
setscrews.
2. Turn on the heat to the crimpers and
allow the crimpers to come up to
temperature, to allow for any thermal
expansion.
NOTE: If using cold seal film, disregard all
reference to temperature settings.
3. Place a single layer of film between the
crimpers.
4. Close the operator guards and jog the
machine to make a cut impression.
5. Add shims in .002" increments and
take impressions until a good, even cut
is obtained.
© Bosch Packaging Technology, Inc.
All rights reserved 2012
6.4.13 Backstand - Adjust the Brake
System
Located above the eccentric are two large
setscrews. Turning these setscrews in or out
will increase or decrease the pressure of the
brakeshoe against the brake hub.
Brake adjustment
setscrews
EN | 21