Bosch Pack201HS Instruction Manual page 100

Pack201 | Maintenance | Section 6
6.2 Cleaning
6.2.1 Daily Cleaning Procedure
These procedures are recommended for
an 8 hour operation. For a shift operation,
these cleaning tasks should be performed
after every shift.
Daily Cleaning Procedure
Assembly
General Equipment
Endseal crimpers
Finwheels
WARNING
The crimpers and finwheels are
best cleaned while hot. Do not
touch them with a bare hand or a
severe burn could result! Use an
insulating device.
CAUTION
When cleaning, use a brass brush
only. A steel brush is too abrasive
and can cause damage. Be very
careful to avoid damaging the wires
going to the heat elements.
© Bosch Packaging Technology, Inc.
All rights reserved 2012
Cleaning Tool
Damp cloth and
industrial soap or
cleaning solution.
Brass brush
(see below)
Brass brush
(see below)
Cleaning Procedure
Clean belts, guides, pushers, and any other items
that come into contact with the product. Remove
any film residue.
Remove any burnt sealing material buildup
from the serrations in both the upper and lower
crimpers.
If it is necessary to clean the knife and anvil slots
in the crimpers, remove the knife and anvil.
Remove any burnt sealing material buildup from
the serrations in the wheels.
EN | 3