Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
Provision equipment port
To provision E1 node timing
1. From the PDH main view, click on the Slot icon to access the Node Timing
To provision a DS1 P32E1DS1 port
1. Click on the P32E1DS1 DS1 card or MSS/DS1 in the resource list area. See
442
a. Select Settings tab.
The Settings tab displays.
b. Select E1 port#n to provision: 01 to 32 for a P32E1DS1 card or 01 to 16 for
an MSS-1.
c. Configure a user label if needed.
d. From the Signal Mode drop-down menu, select signal mode type:
Unframed, Framed, or Disabled.
e. Enter the unique Flow ID number.
f. From the Service Profile drop-down menu, select service profile type,
TDM2TDM or TDM2Eth.
g. E1 port service profile TDM2ETH?
a. If yes, go to step h.
b. If no, go to step k.
All ports on an E1 card must be provisioned to the same method of
clock recovery, either adaptive or differential. After the first port on a
card is provisioned, all remaining ports on the card will default to the
clock recovery method selected on the first port.
h. From the TDM Clock Source drop-down menu, select TDM Clock Source:
Adaptive or Differential.
i. Enter the unique ECID Tx value.
j. Enter the unique ECID Rx value.
k. Click Apply.
The PDH Main View updates adding the provisioned E1 port to the resource
list area.
menu.
Node Timing: timing from the network clock as defined in G.8261. The enabling
of the Node Timing is applied to all E1s of the PDH unit.
By enabling the Node Timing the E1 streams in Rx side are retimed at the output
with the network element clock.
Figure
262.
WebEML User Manual
Advertisement
Table of Contents
