Release 7.0.0 3DB 19286 ACAA Issue 01
Provision cross connections
Verify appropriate port segregation is provisioned to prevent message flooding. Port
segregation should be provisioned between parallel radio paths at both ends when
they exist on the NE. When making a cross connection to one of parallel radio ports,
port segregation should also be provisioned between the Ethernet port and all other
parallel radio ports. Port segregation should also be provisioned between the
Ethernet and radio ports and other Ethernet and/or radio ports where connectivity is
not desirable.
43.9 Radio to radio:
Caution: When parallel radio paths exist between two MSS shelves, port segregation
should be provisioned between the parallel radio paths at both ends to prevent a loss of
traffic.
43.9.1 Prerequisites
Both radios and/or Radio LAG ports must be enabled on the respective card or
Ethernet LAG port provisioning screens.
When making a cross connection between two radio cards:
Ranging Flow ID entry is supported.
Verify appropriate port segregation is provisioned to prevent message flooding. Port
segregation should be provisioned between parallel radio paths at both ends when
they exist on the NE. When making a cross connection to one of parallel radio ports,
port segregation should also be provisioned between the radio port and all other
parallel radio ports. Port segregation should also be provisioned between the radio
ports and other Ethernet and/or radio ports where connectivity is not desirable.
354
• Use the TDM2TDM service profile if the termination points of the circuit are
configured TDM2TDM.
• Use the TDM2ETH service profile if the termination points of the circuit are
configured TDM2ETH.
• Use the SDH2SDH service profile if the termination points of the circuit are
configured SDH2SDH.
WebEML User Manual