Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
Configure radio parameters
Note: The Channel #1 Rx Freq (KHz) field displays the Rx RF Frequency and is the result
of the following calculation: RX Frequency = TX Frequency - Shifter Frequency
Note: In a Protected radio configuration, the Main and Protect radio channels use the same
CT screen. The parameters on the Spare (Channel #0) part of the screen are the same as
the Main (Channel #1) part of the screen. Channel #0 fields will be automatically populated
to match Channel #1.
41. Select an action.
42. Provision the radio for Adaptive Modulation
Note: For MPT-HC-HQAM/XP-HQAM, the Reference Modulation should be set to a value
lower than or equal to 256 QAM.
In the ANSI market for MPT-HC-HQAM/XP-HQAM, the Reference Modulation should also
be equal to the Minimum modulation.
864
ix. Enter the MPT-HC/HQAM radio channel User Label, if applicable.
x. Click Apply.
a. To
Provision the MPT ODU 1+1 FD spare radio
b. To
Provision the MPT ODU Manual Transmit Power Level
step 48.
c. To
Provision the MPT ODU Automatic Transmit Power Control
to step 53.
Open the appropriate radio main view depending on your radio configuration
and select the Settings tab; see
channel, go to step 45.
Figure
650.
WebEML User Manual
(RTPC), go to
(ATPC), go
Advertisement
Table of Contents
