Motion commands
9.15 Chamfer, rounding (CHF, CHR, RND, RNDM, FRC, FRCM)
Example 2: Rounding between two straight lines
Program code
...
N30 G1 Z... RND=2 FRC=50
N40 G1 X...
...
Example 3: Rounding between straight line and circle
The RND function can be used to insert a circle contour element with tangential connection
between the linear and circle contours in any combination.
Program code
...
N30 G1 Z... RND=2 FRC=50
N40 G3 X... Z... I... K...
...
274
•
MD20201 Bit 0 = 1 (derived from
previous block)
•
G71 is active.
•
The radius of the rounding should be
2 mm and the feedrate for rounding
50 mm/min.
•
MD20201 Bit 0 = 1 (derived from
previous block)
•
G71 is active.
•
The radius of the rounding should be
2 mm and the feedrate for rounding
50 mm/min.
Programming Manual, 09/2011, 6FC5398-1BP40-2BA0
Fundamentals