Siemens SIMATIC NET SCALANCE S615 Configuration Manual page 219

802.1Q VLAN Bridge: Important rules for VLANs
Make sure you keep to the following rules when configuring and operating your VLANs:
● Frames with the VLAN ID "0" are handled as untagged frames but retain their priority value.
● As default, all ports on the device send frames without a VLAN tag to ensure that the end
node can receive these frames.
● You will find the factory assignment of the ports in the section "VLAN (Page 35)".
● The VLANs are in different IP subnets. To allow these to communicate with each other, the
route and firewall rule must be configured on the device.
● If an end node is connected to a port, outgoing frames should be sent without a tag (static
access port). If, however, there is a further switch at this port, the frame should have a tag
added (trunk port).
Procedure
Requirement:
For Base Bridge mode "802.1Q VLAN Bridge" is set
Creating a new VLAN
1. Enter an ID in the "VLAN ID" input box.
2. Click the "Create" button. A new entry is generated in the table. As default, the boxes have
"-" entered.
3. Enter a name for the VLAN under Name.
4. Specify the use of the port in the VLAN. If, for example you select M, the port is a member
of the VLAN. The frame sent in this VLAN is forwarded with the corresponding VLAN tag.
5. Specify the mode of the device.
6. Click the "Set Values" button.
SCALANCE S615 Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C388-08
Configuring with Web Based Management
4.7 "Layer 2" menu
219