Ntp Client - Siemens SIMATIC NET SCALANCE S615 Configuration Manual

Configuring with Web Based Management
4.5 "System" menu
3. Select one of the following options from the "SNTP Mode" drop-down list:
– Poll
– Listen
4. In "SNTP Server Address", enter the address of the SNTP server whose frames will be used
to synchronize the time of day.
5. In "SNTP Server Port", enter the port via which the SNTP server is available. The port can
only be modified if the IP address of the SNTP server is entered.
6. In "Poll Interval[s]", enter the time in seconds after which a new time query is sent to the time
server.
7. Click the "Set Values" button.
4.5.8.5

NTP Client

Automatic time-of-day setting with NTP
If time synchronization is to take place via NTP, define the time server that is used to
synchronize the time.
Note
To avoid time jumps, make sure that there is only one time server in the network.
166
For this mode, you need to configure the following:
- time zone difference (step 2)
- query interval (step 4)
-time server (step 5)
- Port (step 7)
- complete the configuration with step 8.
For this mode, you need to configure the following:
- time difference to the time sent by the server (step 2)
- time server (step 5)
- port (step 7)
- complete the configuration with step 8.
SCALANCE S615 Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C388-08