Siemens SINUMERIK 840D sl Function Manual page 722

Detailed description
2.10 System settings for power-up, RESET/part-program end and part-program start
2.10 System settings for power-up, RESET/part-program end and part-
program start
Concept
The control system response can be altered for functions such as G codes, tool length
compensation, transformation, coupled axis groupings, tangential followup, and
programmable synchronous spindle after
• Power up (power ON),
• Reset/part program end and
• Part program start
The
MD20110 $MC_RESET_MODE_MASK (defining the initial controller setting after Reset / part
program start)
MD20150 $MC_GCODE_RESET_VALUES (RESET position of G groups) and its extension
MD20152 $MC_GCODE_RESET_MODE (defining the initial controller setting
during Reset) and
MD20112 $MC_START_MODE_MASK (defining initial controller setting
after part program start)
.
For certain applications (e.g., grinding) it is advisable not to capture the reset position of
individual functions until part program start. This is possible through the appropriate setting
of MD20110, MD20150, MD20152 and MD20112.
Table 2-12
Status
Power up (POWER ON)
RESET/part program end
Part program start
164
Change system settings by means of MD
Can be changed in MD
MD20110 $MC_RESET_MODE_MASK
MD20150 $MC_GCODE_RESET_VALUES
MD20110 $MC_RESET_MODE_MASK
MD20150 $MC_GCODE_RESET_VALUES
MD20152 $MC_GCODE_RESET_MODE
MD20110 $MC_START_MODE_MASK and
MD20112 $MC_RESET_MODE_MASK
Basic logic functions: Mode group, channel, program operation, reset response (K1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0