Siemens SIPLUS HCS Series Operating Instructions Manual page 197

Dismantling the fan module
Proceed as follows to dismantle the fan module:
Figure 12-4 Dismantling the fan module
Steps
Mounting the fan module
Refer to section Mounting the fan module (Page 56) for instructions on mounting a
fan module.
SIPLUS HCS4200 PROFINET/PROFIBUS DP
Operating Instructions, 07/2019, A5E35066204A/006
1
Remove the fan connector
•
Recommendation: Pulling directly at the cable makes it easier to remove the
①
connector .
Pull the fan cable out of the holder.
•
② ③ ④
Steps , ,
the holder without using tools.
2
Release the two fastening screws
3
Lift the fan module at the rear and push it backward
4
Lift the fan module
shown in the figure illustrate how you can remove the fan cable from
⑤
⑦
and pull the cable out through the opening in the housing
Service and maintenance
12.4 Replace fan
⑥
⑧
195