Table of Contents
Advertisement
56/69
Bosch Rexroth AG
Maintenance
8.3
Connecting two VDPs via the Y-Repeater
Rexroth IndraControl VDP 16.1/40.1/60.1 Operator Display
To connect two VDP displays to one control cabinet PC (IPC), the Y-repeater
is available as accessories. The Y-Repeater is located between the control
cabinet PC (IPC) and the two VDP displays. The image signals of the control
cabinet PC (IPC) are sent simultaneously via the Y-Repeater to the two VDP
displays. However, you select via a 24 V signal which of the two VDP displays
can be used as active VDP to operate the control cabinet PC. For safety rea‐
sons only one of the VDP displays can be active. The Y-repeater indicates
which VDP is active.
Please find the connections of the Y-repeater in
Y-Repeater" on page
50.
NOTICE
If you use a Y-Repeater, you may only operate with VDP displays of the same
type.
NOTICE
The end devices (mouse, keyboard) connected to the two VDP displays must
be of the same type (e.g. a two-key mouse).
NOTICE
During the booting process of the control cabinet PC (IPC) you must not switch
from one VDP to another.
NOTICE
The operator displays must be supplied with voltage either before or at least at
the same time as the control cabinet PC (IPC).
DOK-SUPPL*-VDP16/40/60-PR03-EN-P
chapter 7.2 "Intefaces at the
Missing screen output or incorrect screen res‐
olution if VDPs with different resolution are
connected.
No switching between two VDPs possible if the
connected end devices (mouse, keyboard) are
not of the same type.
Missing screen output or incorrect screen res‐
olution if you switch during the booting proc‐
ess.
Missing screen output or incorrect screen res‐
olution if the voltage supply of the VDP is
switched on after switching on the control cab‐
inet PC (IPC).
Advertisement
Table of Contents
