Interfaces; Interfaces At The Vdp; View On The Connector Panel; General Information - Bosch Rexroth IndraControl VDP 16.1 Project Planning Manual

DOK-SUPPL*-VDP16/40/60-PR03-EN-P
Rexroth IndraControl VDP 16.1/40.1/60.1 Operator Display
7

Interfaces

7.1

Interfaces at the VDP

7.1.1

View on the Connector Panel

7.1.2

General Information

7.1.3

Overview

Fig.7-1: Interface to the control cabinet PC
NOTICE
Use only shielded cables and metallic, conductive connectors or coupling hous‐
ings with large-area shield support.
NOTICE
Ensure that the functional earth ground is connected, because otherwise the
electronics can be destroyed by a potential difference between the VDP
16.1/40.1/60.1 and the PC if the voltage supply is interrupted to only one device
and established again. A direct connection between functional earth ground
and VDP xx.1 and VPB 40.1, VSB 40.1 is optimal. If the functional earth ground
is wired at a neutral point, also the control cabinet PC (VPB 40.1, VSB 40.1)
must be connected to this neutral point.
Interfaces
Designa‐
tion at the Connection type
housing
X13 DC-24-V voltage supply
> required if an Y-repeater is
used
XUSB1
2 USB interfaces
XUSB2
2 USB interfaces
Bosch Rexroth AG
Malfunctions due to insufficient shielding!
Material damages to electronics due to missing
functional earth ground connection!
Connector type / in‐
tegrated
Weidmüller connec‐
tor terminal,
MSTB 1.5, 3-pin
USB female con‐
nector, 4-pin, type A
USB female con‐
nector,
4-pin, type A
45/69
Interfaces
Mating connector or
cable (from outside)
Weidmüller female
connector terminal,
MSTB 1.5, 3-pin
USB male connec‐
tor, 4-pin,
USB connector,
4-pin,