05.07
User/Password
These two parameters correspond to the user name and associated password for
the automatic login (type of login: No Login dialog).
Note
The user DNC with password DNC is defined in DNC IFC SINUMERIK as default
setting. After installation of DNC, the preset user should be deleted and replaced
by your own user ID, as the DNC user has administration rights per default. The
preset user should then also be replaced by a user configured in DNC in
DNC IFC SINUMERIK.
Extract from the configuration file:
Section[USER]
Name = DNC
Password =DNC
Assignment of users to protection levels
A user can be assigned to each of the eight protection levels 0-7 in accordance
with SINUMERIK HMI Advanced. Depending on the current type of login, it is
therefore possible to start DNC IFC SINUMERIK with the rights of one of the
entered users.
Extract from the configuration file:
Section[USER]
ACCESSLEVEL0 =HMISystem
ACCESSLEVEL1 =HMIManufacturer
ACCESSLEVEL2 =HMIService
ACCESSLEVEL3 =HMIUser
ACCESSLEVEL4 =HMIKeyPosition3
ACCESSLEVEL5 =HMIKeyPosition2
ACCESSLEVEL6 =HMIKeyPosition1
ACCESSLEVEL7 =HMIKeyPosition0
© Siemens AG 2010 All Rights Reserved
Motion Control Information System DNC (FBDN) - 04/10 Edition
DNC IFC SINUMERIK - Downloading NC Data via a Network (FBDN2)
5 Configuration file
FBDN2/5-55