05.07
Fig. 10-3: DNC Plant: Machine properties transmission mode: Serial without protocol
Station
In DNC Plant, enter the name of the station to which the machine is to be assigned.
This entry is not necessary in DNC Cell because there is only one station.
Note
When you confirm the Properties dialog, a plausibility check is carried out to
determine whether the station name has already been assigned to a tool setting
device. In this case, the dialog remains open until a correct station name has
been entered.
© Siemens AG 2010 All Rights Reserved
Motion Control Information System DNC (FBDN) - 04/10 Edition
DNC Plant/DNC Cell (FBDN1)
10 Configuration
FBDN1/10-163