Siemens Sinumerik 840D sl Function Manual page 325

05.07
DNC  DM file type conversion
In the DNC  DM file type conversion frame, the conversion of file types from
the DNC system to the Data management server PCU/MMC can be specified, or
existing conversions deleted or changed. The conversion is performed with the
download of the data from the DNC system to the data management server of the
SINUMERIK 840D.
!
Important
The conversion is only performed when the Evaluation of the internal PCU path
is not performed in the DNC tab. Selection: No evaluation.
Only specify file types that are known in the DNC system (DNCDATATYPE table)
as DNC type.
Extract from the configuration file:
Section [DNCMMCTypeTab]
DNCMMCTypeCount = 2
DNCMMCType1=TXT MPF
DNCMMCType2=DOC INI
Note
The conversion only takes effect with
DNCMMCTypeCount
© Siemens AG 2010 All Rights Reserved
Motion Control Information System DNC (FBDN) - 04/10 Edition
DNC IFC SINUMERIK - Downloading NC Data via a Network (FBDN2)
DriveInternPath=0
= contains the number of file types that are converted.
5 Configuration file
.
FBDN2/5-43