DNC Plant/DNC Cell (FBDN1)
10 Configuration
10.5.6 Configuration dialog for the tool setting device
General
Tool setting devices are always inserted directly underneath the plant root.
Fig. 10-25: Properties of tool setting device
Station
The assignment of a tool setting device to the HMI workstation is made via the
station name, which must be unique in DNC Plant. This entry is not necessary in
DNC Cell because there is only one station.
Note
Transmission module
FBDN1/10-218
The station name configured for a tool setting device must not be
used for any other tool setting device or machine. When you confirm
the Properties dialog, a plausibility check is carried out to determine
whether the station name has already been assigned to a tool
setting device or a machine. In this case, the dialog remains open
until a correct station name has been entered.
Motion Control Information System DNC (FBDN) - 04/10 Edition
© Siemens AG 2010 All Rights Reserved
05.07