Configuration - Calculations - Siemens SINAMICS S120 System Manual

Commissioning

4.9 Configuration - calculations

4.9 Configuration - calculations
This dialog is only displayed in the change run if previously data were changed in the
dialogs.
Figure 4-8
The values to preassign the parameters are calculated from the valve, cylinder and system
data.
You can activate the pre-assignment of the following parameters:
● Reference values
● Controlled system gain and natural frequencies
● Characteristic data
● Controller values
● Limit values
62
Configuration - calculations
System Manual, 04/2015, 6SL3097-4BA00-0BP1
Hydraulic Drive