Parameter Assignment; Parameterization With Free Function Blocks - Siemens SINAMICS S120 Equipment Manual

Options
8.19 L34, output-side circuit breaker
8.19.4

Parameter assignment

8.19.4.1

Parameterization with free function blocks

The free function blocks are used for the parameterization described in this section. You
must start by activating them.
Activating the free function blocks
To be able to work with the free function blocks, they must first be activated/enabled:
● If you are not certain that the project in the STARTER corresponds to the drive
● In Offline mode -> Right-click the drive object -> Properties -> Activate the "Free function
● You will then need to perform a download (load data to the target device) so that the
Setting the sampling time for run-time group 0 of the free function blocks
To activate the interconnection, parameterization (in the expert list) must be carried out as
follows (in this example, it has been assumed that the drive is called "Drive_1" in the project
navigator):
● (Drive_1) p20000[0] = 3
378
configuration, you should start with an upload (load data to PG).
blocks" in the "Drive Properties" interactive screenform under "Select function modules".
"Free function blocks" function module is activated in the drive.
The sampling time of the "Free function blocks" run-time group 0 is classified as
3 (= 3 x r20002).
S120 Cabinet Modules Equipment Manual
Manual, (GH5), 10/2008, A5E00427098A