Configuring Neighbor Discovery - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
NOTE
MPLS must be enabled and MPLS label bindings must be removed before enabling LDP. Refer to
Section 5.39.3, "Enabling/Disabling MPLS Routing"
for further information.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.39.7.7

Configuring Neighbor Discovery

To configure the LDP neighbor discovery, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Navigate to mpls » ldp » discovery. The LDP Discovery Hello Configuration form appears.
Figure 945: LDP Discovery Hello Configuration Form
1. LDP Hello Interval Box
3. Configure the following parameter(s) as required:
Parameter
LDP Hello Interval
LDP Hello Holdtime
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Configuring Neighbor Discovery
1
2
2. LDP Hello Holdtime Box
Description
Default: 5
The time (in seconds) between the sending of consecutive Hello messages.
Default: 15
The time (in seconds) that a discovered LDP neighbor is remembered without receipt of
an LDP Hello message from the neighbor.
and Section 5.39.5.4, "Deleting a Static Label"
Chapter 5
Setup and Configuration
817