N Mode Sample Program - Panasonic AFPE224300 User Manual

4.3 N mode sample program

- Sample program
- Screen display
st
On N mode 1 screen, EV0 (red) and SV0 (orange) are displayed in the upper and lower sections
respectively.
nd
On N mode 2 screen, EV1 (red) and SV1 (green) are displayed in the upper and lower sections
respectively.
- Front switches
Pressing the operation switch "0" to "4" on N mode 1
mode for SV0.
Note: Data blinks in the change mode.
When the display selection switch "1/2/SET" is pressed for about one second, the data for the SV0
is changed and the blinking of the data stops.
Note: Data which is out of the specified range (16-bit) cannot be written.
When the display selection switch "1/2/SET" is pressed, the current screen changes to 2
The operation switches ("0" to "5") are locked by the program on 2
Even when the operation switch is pressed, therefore, SV1 cannot be changed.
Reference: For further information, see "Locking the Switch" in A.2 I/O Allocation."
Pressing the "MODE" switch for about 2 seconds locks both display selection switch and operation
switch. In this "LOCK" status, the display and data cannot be changed. In addition, the "LOCK"
status is not cancelled even when the power turns ON/OFF.
Pressing the "MODE" switch for about 2 seconds again unlocks the "LOCK" status. At this time, the
"LOCK" display turns off.
4-10
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
st
screen changes the mode to the change
nd
screen. (Y32 is ON.)
nd
screen.