Siemens SIDOOR ATD401W System Manual page 270

Connecting and commissioning
9.6 Commissioning the control unit on the fieldbus
Commissioning the control unit on PROFINET
We recommend the following initial commissioning procedure for a control unit as IO device
on PROFINET IO:
Table 9- 4
Step
1
2
3
4
5
6
7
270
Procedure for commissioning the control unit as an IO device on PROFINET IO
Procedure
Commission the control unit without a fieldbus connec-
tion as described in the previous sections.
Configuring an IO controller
Switch on the supply voltage for IO controller
Switch on supply voltage for control unit (IO device)
Load the configuration into the I/O controller
Switch I/O controller to RUN mode
Controlling LEDs on the control unit
See...
Sections Preparing the con-
trol unit (Page 263) to Con-
necting digital inputs
(Page 267)
Documentation of the IO
controller
Documentation of the IO
controller
Connecting the power supply
to the network and executing
a learn run (Page 266) sec-
tion
Online help of the configura-
tion tool, e.g. STEP 7
Documentation of the IO
controller
Final settings and checks
(Page 271) section
ATD4xxW Door Controller for Industrial Applications
System Manual, 01/2017, A5E38080677-AB