Huawei OptiX OSN 550 Configuration Manual page 244

4 Configuring Ethernet Services
4-90
Parame Value in This Example Description
ter
Hold- VCTRUNK1: 2000
off Time
VCTRUNK2: 2000
(ms)
WTR VCTRUNK1: 300
Time(s)
VCTRUNK2: 300
TSD VCTRUNK1: Disabled
VCTRUNK2: Disabled
Min. VCTRUNK1: 256
Member
VCTRUNK2: 256
s -
Transmi
t
Directio
n
Min. VCTRUNK1: 256
Member
VCTRUNK2: 256
s -
Receive
Directio
n
l Click the Bound Path tab. Click the Configuration button. Set the following
parameters in the Bound Path Configuration dialog box that is displayed. Then, click
Apply.
User Paramete
r
User Configura
ble Ports
F1←
→user
F2
Ava Lev
ilab el
le
Bou
nd
Pat
hs
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OptiX OSN 550 Multi-Service CPE Optical Transmission
In this example, this parameter adopts the
default value 2000. This parameter can also
be set according to the requirement of the
user.
In this example, this parameter adopts the
default value 300. This parameter can also be
set according to the requirement of the user.
In this example, the TSD function is disabled.
The LCAS does not check the B3 bit error or
BIP status of the VCTRUNK members.
Sets the min. members - transmit direction.
When the LCAS is enabled and the number
of available members is smaller than this
value, an alarm is reported.
Sets the min. members - receive direction.
When the LCAS is enabled and the number
of available members is smaller than this
value, an alarm is reported.
Value in Description
This
Example
VCTRUN As shown in
K1 EFS8 board is used by the service between user
F1 and user F2.
VC12-xv The service between user F1 and user F2 uses
a 10 Mbit/s bandwidth. Hence, five VC-12s
need to be bound.
For the method of computing the bound
timeslots based on the service bandwidth, see
6.3 Ethernet Service Bandwidths Carried by
VCTRUNKs of Ethernet
Configuration Guide
Figure 4-31, VCTRUNK1 of the
Boards.
Issue 02 (2011-06-30)
System