Huawei OptiX OSN 550 Configuration Manual page 233

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
3.
Issue 02 (2011-06-30)
Parame Value in This Example Description
ter
Set VCTRUNK1: -
Inverse
Value
for CRC
l Click the Bound Path tab. Click the Configuration button. Set the following
parameters in the Bound Path Configuration dialog box that is displayed. Then, click
Apply.
User Parameter
User D1 Configurab
le Ports
←→user
D2
User E1
←→user
Av Leve
E2
aila l
ble
Bo
und
Pat
hs
Serv
ice
Dire
ction
Avai
lable
Reso
urce
s
Avai
lable
Tim
eslot
s
Configure the Ethernet private line services between user D1 and user D2 and between user
E1 and user E2.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
When Mapping Protocol is set to GFP, this
parameter is valid and adopts the default
value -. Set Inverse Value for CRC of the
VCTRUNKs on the Ethernet boards of the
interconnected equipment at both ends must
be set to the same value.
Value Description
in This
Examp
le
VCTR As shown in Figure
UNK1 used by the service between user D1 and user
D2 and the service between user E1 and user
E2.
VC12- The service between user D1 and user D2 and
xv the service between user E1 and user E2 share
a 20 Mbit/s bandwidth. Ten VC-12s need to be
bound.
For the method of computing the bound
timeslots based on the service bandwidth, see
6.3 Ethernet Service Bandwidths Carried
by VCTRUNKs of Ethernet
Bidirect The service between user D1 and user D2 and
ional the service between user E1 and user E2 are
bidirectional services.
VC4-4 Select VC4-4.
For the resources used by other boards, see
Requirements for Binding Paths with
VCTRUNKs on Ethernet
VC12-1 Ten VC-12s need to be bound. In this example,
to the first to the tenth VC-12s need to be selected
VC12-1 in sequence.
0
4 Configuring Ethernet Services
4-29, VCTRUNK1 is
Boards.
Boards.
6.2
4-79