Configuring Epl Services On An Ethernet Switching Board - Huawei OptiX OSN 550 Configuration Manual

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
Step 3 Configure the EPL services of user A2 and user B2 on NE3.
Refer to
Step 4 Check whether the service between user A1 and user A2 and the service between user B1 and
user B2 are correct. For the operation procedure, see Testing Ethernet Service Channels.
Step 5 Enable the performance monitoring function of the NEs. For details, see Setting Performance
Monitoring Parameters of an NE.
Step 6 Back up the configuration data of the NEs. For details, see Backing Up the NE Database to the
SCB Board.
----End
Relevant Task
If the services are configured incorrectly and thus need to be deleted, see
Private Line
4.5 Configuring EPL Services on an Ethernet Switching
Board
EPL services provide the point-to-point Ethernet transparent transmission solution with the
bandwidth exclusively occupied. EPL services are applicable when the communication
equipment that is used to access the client-side data in the transmission network does not support
VLANs or when the VLAN planning must be kept secret to the network operator.
4.5.1 Networking Diagram
The completely isolated data services of two users at a station must be transported to another
station.
4.5.2 Signal Flow and Timeslot Allocation
Issue 02 (2011-06-30)
Parameter Value in
This
Example
Sink Slot 5-SL4D-2
(SDH-2)
Sink VC4 VC4-1
Sink 1-15
Timeslot
Range(e.g.
1,3-6)
Activate Yes
Immediatel
y
Step 1 and configure the EPL services for users A2 and B2.
Services.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
As shown in Figure 4-23, the service signals are
transmitted from 5-SL4D-2(SDH-2) to 5-SL4D-1
(SDH-1). In this example, Sink Slot is set to 5-SL4D-2
(SDH-2).
It is recommended that you set Sink Slot to be the same
as Source Slot.
The service between user A1 and user B1 uses timeslots
1-15.
-
4 Configuring Ethernet Services
5.4.3 Deleting Ethernet
4-43