Hitachi AMS 2100 Hardware Manual page 236

•
Date
Time
Time Zone
Automatically adjust clock for
daylight saving changes
NTP
IP Address
Synchronization State
The Array performs the synchronization timing by communicating to the
NTP server at the time of the following events.
• Setting NTP server (specify IP address of NTP server) and editing NTP
server.
• Starting the array.
7–54
Table 7-17: Date & Time
Item
Configuration
Hitachi AMS 2100/2300 Storage System Hardware Guide
Description
The date of the array clock is displayed.
The time of the array clock is displayed.
The time zone set in the array is displayed.
Whether Automatically adjust clock for daylight
saving changes of the array is enabled or disabled
is displayed.
The information of the NTP server 1 and the NTP
server 2 registered in the array are displayed.
The IP address registered for the NTP server is
displayed. When the IP address is not registered,
N/A message is displayed.
The synchronization status (success or failure) of the
time when the array communicates with the NTP
server last time is displayed. If it does not
communicate with the NTP server after setting the
NTP server or starting the array, Not Executed
message is displayed.