Hitachi AMS 2100 Hardware Manual page 143

• Unpack the unit indoors. Take care not to unpack it in dusty places, in
direct sunlight, or where rain or moisture are present.
• Work on the unpacking in the place where a rapid difference of
temperature does not occur. It may have dew condensation when it is
unpacked in the place where a difference of temperature is extreme.
• Verify that the unpacking and installation of the rack are performed by
service personnel.
The array within the outer package is shown in the following illustration.
Complete the following steps to unpack an AMS 2100/2300 array.
1. Remove the outer package and packing materials.
2. Take the array out of the polyethylene bag.
3. Remove tapes, etc. applied to the array.
4. Remove desiccating agent from the lower section of the array.
5. Check the exterior of the array visually for distortion or damage that
occurred while the array was being transported to your installation site.
Hitachi AMS 2100/2300 Storage System Hardware Guide
Installation
5–25