Hitachi AMS 2100 Hardware Manual page 202

Search array screen
This screen sets the criteria that is used when searching a storage network
for arrays.
Select one of the following choices:
•
•
7–20
Adding a Specific Array (see below to add multiple arrays)
a. If you know the IP address of a specific array that you want to add,
click Specific IP address or Array Name: and enter either the IP
address of the array or the array name. Click Next to continue and
open the Add Array screen.
Adding Arrays Within a Range of IP addresses
a. If you know the range of IP addresses that includes one or more
arrays that you want to add, click Range of IP addresses to
Search and enter the low and high IP addresses of that range. The
range of addresses must be located on a connected local area
network (LAN).
b. Click Next to continue and open the Add Array screen.
NOTE: if any of the IP addresses you entered is incorrect, when you click
Next, Navigator 2 displays the following message:
Failed to connect with the array. Confirm the array status and the LAN
environment, and then try again.
Configuration
Hitachi AMS 2100/2300 Storage System Hardware Guide