Simulating machining
6.7 Program control during simulation
6.7
Program control during simulation
6.7.1
Changing the feedrate
You can change the feedrate at any time during the simulation.
You can track the changes in the status line.
Note
If you are working with the "Simultaneous recording" function, the rotary switch (override) on
the control panel is used.
Procedure
Toggling between "Override +" and "Override -"
Selecting the maximum feedrate
174
1.
Simulation is started.
2.
Press the "Program control" softkey.
3.
Press the "Override +" or "Override -" softkey to increase or decrease
the feedrate by 5%.
- OR -
Press the "Override 100%" softkey to set the feedrate to 100%.
- OR -
Press the "<<" softkey to return to the main screen and perform the
simulation with changed feedrate.
Press the <CTRL> and <Cursor down> or <Cursor up> keys to toggle
between the "Override +" and "Override -" softkeys.
Press the <CTRL> and <M> keys to select the maximum feedrate of
120%.
Operating Manual, 01/2015, 6FC5398-6AP40-5BA2
Universal