Sony 3026 Programmer's Manual page 86

Command Descriptions
Arguments
Responses
Examples
TRIGger:FREQMASK:CONDition (?)
Group
Related Commands
Syntax
Arguments
Responses
Examples
2 70
MAXimum
sets the block count to the maximum.
MINimum
sets the block count to the minimum.
<numeric value>::=<NR1>
The maximum block count is determined as follows, depending on the FFT point
setting:
For 256 points : 4,000/current block size setting
For 1,024 points : 1,000/current block size setting
<numeric value>
:TRIGGER:COUNT 20
sets the block count to 20.
The TRIGger:FREQMASK:CONDition? command sets the condition that causes a
trigger to occur when the frequency mask is being used. The TRIGger:FREQ
MASK:CONDition query returns the current setting.
TRIGGER
None
TRIGger:FREQMASK:CONDition {BREAK|INSIDE}
TRIGger:FREQMASK:CONDition?
BREAK
causes a trigger when a waveform value outside the trigger mask
pattern is encountered.
INSIDE
causes a trigger when a waveform value inside the trigger mask
pattern area is encountered.
{BREAK|INSIDE}
:TRIGGER:FREQMASK:CONDITION BREAK
causes a trigger when a waveform value outside the trigger mask pattern area is
encountered.
block count
3026 Programmer Manual