Table 2-8: Source Commands; Table 2-9: Status Commands - Sony 3026 Programmer's Manual

Command Groups
SOURCE Commands
STATUS Commands
2 12
Table 2 7: SENSE commands (Cont.)
Header
SENSe:AVERage:COUNt(?)
SENSe:AVERage:RESET
SENSe:AVERage:TYPE(?)
SENSe:BLOCK[:SIZE](?)
SENSe:DATa?
SENSe:FFT[:SIZE](?)
SENSe:FRAMe:PERIOD(?)
SENSe:FREQuency:CENTer(?)
SENSe:FREQuency:SPAN(?)
SENSe:GAIN:EXTernal:GAIN(?)
SENSe:GAIN:EXTernal:STATe(?)
SENSe:LEVel(?)
SENSe:LEVel:UNIT(?)
SENSe:RF(?)
SENSe:WINDow[:TYPE](?)
Use these commands to select the reference clock signal source.
Table 2 8: SOURCE commands
Header
SOURce:ROSCillator:SOURce(?)
Use these commands to address the instrument status and event queue.
Table 2 9: STATUS commands
Header
STATus:OPERation[:EVENt]?
STATus:OPERation:ENABle(?)
STATus:PRESet
STATus:QUEue[:NEXT]?
Description
Set or query the number of times of averaging
Reset the average/peak hold mode
Set or query the average /peak hold mode
Set or query the block size
Query the data for the logical flame that active
marker is on
Set or query the number of FFT sampling points
Set or query the frame period
Set or query the center frequency
Set or query the frequency span setting
Set or query the gain correction value
Set or query the gain correction on/off state
Set or query the reference level
Set or query the display unit for vertical axis
Set or query the input range
Set or query the FFT window type
Description
Set or query the clock signal internal/external
selection
Description
Destructive query of status register
Set or query register to record event transitions
Reset all status enable register
Display event in error/event queue
3026 Programmer Manual