Examples; General Start-Up Of A Compile Cycle Function - Siemens sinumerik 840D sl Function Manual

Examples

4.1

General start-up of a compile cycle function

Note
The compile cycles are supplied as loadable modules. The general procedure for installing
such compile cycles can be found in TE0. You can find the specific supplements to this
compile cycle in the section entitled "Update of NCKOEM_CC_0013_01.02.00".
Saving SRAM contents
As the first step in the installation of a compile cycle function, the technology card is
exchanged for the original card provided in the NCU.
This step is equivalent to any procedure which involves the normal upgrade of your software
platform and requires the deletion of any (battery-supported) static control memory. To avoid
the consequential loss of all data in the SRAM, back up the SRAM before performing the
operation.
Please proceed as follows:
1. Enter the machine manufacturer password.
2. Switch to the "Services" operating area.
3. Press the "Series start-up" softkey.
4. Select "NC" and "PLC" as the areas to be saved and enter a name of your choice for the
5. If the control system contains machine-specific compensation data, then these must be
These archive files will enable you to restore the original status if required.
Special functions: MCS Coupling (TE6)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0
archive file to be created on the hard disk. Finish by pressing the RETURN key.
saved in a separate archive file:
– Press the "Data out" softkey.
– Select from the "NC active data" menu:
– "Measuring system compensations"
– "Sag/angularity comp."
– "Quadrant error compensation".
– Save these data by selecting softkey "Archive...".
– Enter another file name for a second archive file.
4
17