Siemens sinumerik 840D sl Function Manual page 329

2.5.4.11 Condition at RESET (CPMRESET)
With RESET, the coupling can be activated, deactivated or the current status can be
retained. The behavior can be set separately for each coupling module.
Programming
Syntax:
Identifiers:
Functionality:
Reset response: Type: STRING
Special functions: Axis Couplings and ESR (M3)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0
CPMRESET[FAx]= "<Reset behavior>"
Coupling Mode RESET
Defines the behavior of a coupling at RESET.
Range of values:
"NONE" The current state of the coupling is retained.
"ON" When the appropriate coupling module is created, the
coupling is switched on. All defined leading axis
relationships are activated. This is also performed
when all or parts of these leading axis relationships
are active, i.e. resynchronization is performed even
with a completely activated coupling.
"OF" An active overlaid motion is also braked to standstill.
The coupling is then deactivated. When the relevant
coupling module was created without an explicit
definition (CPDEF), the coupling module is deleted.
Otherwise it is retained, i.e. it can still be used.
"OFC" Possible only in spindles!
The following spindle continues to traverse at the
speed/velocity that applied at the instant of
deactivation. The coupling is switched off. When the
relevant coupling module was created without an
explicit definition (CPDEF), the coupling module is
deleted. Otherwise it is retained, i.e. it can still be
used.
"DEL" An active overlaid motion is also braked to standstill.
The coupling is then deactivated and then deleted.
"DELC" Possible only in spindles!
The following spindle continues to traverse at the
speed/velocity that applied at the instant of
deactivation. The coupling is deactivated and then
deleted.
Detailed description
2.5 Generic coupling
109